Needless tension applied using that process. If anyone tied off my XLR leads like that, they'd not be working for me again.
(, Sun 1 Mar 2009, 11:40, Reply)
For me
it's make a loop appropriate to the type of cable, to prevent damage to the copper cores, then about 2-3 loops before I'm finished, wrap the wire around the loop like a coil, as I'm looping, then insert the two connectors through a couple of wires in the loop to prevent them untangling. No stress on the wires, takes about 1 minute to undo at worst, everyone's happy!
(
DavyBoyInGravyJoy Grey Goose Vodka on Ice, nothing finer, Sun 1 Mar 2009, 12:10,
Reply)