b3ta.com board
You are not logged in. Login or Signup
Home » Messageboard » XXX » Message 9253234 (Thread)

# The fluid required has to retain cohesion when sandwiched
between latex and, say, a clear plastic layer.

Water rots latex and spreads evenly.
Oil rots latex quickly, and spreads.
Silicone doesn't rot but still spreads evenly.

Was hoping to utilise the same principle as that in a lava lamp, but not with these materials.
Next I'll try a multiple-layer, e.g.

Plastic
Fluid
Plastic
White latex

Generally, plastics are less likely to react but are less form-fitting than latex.
I was inspired to this method by the original description of the mask fabric in which Rorschach learns to cut the stuff using heated scissors.
(, Mon 9 Mar 2009, 20:26, archived)
#
how about some of that kiddie play slime stuff between sheets of clear silicone, bonding the silicone might prove tricky as only silicone is really any good at bonding silicone, not sure how you'd keep the edges dry/clean to allow it to bond, probably best to work off a cast of a face to make a mask

ky gel/lube stained with something for use with latex?
(, Mon 9 Mar 2009, 20:33, archived)
# Could be interesting
Isn't it water-based?
Would it be any better than, say, gelatine?
I could use a slime/wax or gelatine/wax system, much as in a lava lamp.
(, Mon 9 Mar 2009, 20:36, archived)
# i think so
but it shouldn't cause problems with silicone.
(, Mon 9 Mar 2009, 20:40, archived)
# I've had a quick look around,
And other than using a ferrofluid sandwiched between two inert membranes
or a black stained wax manipulated by alternating heat pads on your face, I can't even begin to solve it.
(, Mon 9 Mar 2009, 20:46, archived)
# *looks around for ferrofluids*
Might not need heat pads if you can get the melting point of the wax down to facial body temperature.
(, Mon 9 Mar 2009, 21:07, archived)