I'd have to out 20mm at least
which means hubcentrics and a cunt for the front wheel bearings, which on a six-cylinder isn't a good idea, plus it means the same at the back to compensate, so 100quid all round for some aluminium discs. No thanks.
( Grrrmachine the indifference engine, Fri 26 Jun 2009, 23:15, archived)

I'm going to take a rasp and try to shave off a few millimetres from the tie rod
and if that works, I'll get proper high quality low profile ones
( Grrrmachine the indifference engine, Fri 26 Jun 2009, 23:20, archived)