Tightwads
There's saving money, and there's being tight: saving money at the expense of other people, or simply for the miserly hell of it.
Tell us about measures that go beyond simple belt tightening into the realms of Mr Scrooge.
( , Thu 23 Oct 2008, 13:58)
There's saving money, and there's being tight: saving money at the expense of other people, or simply for the miserly hell of it.
Tell us about measures that go beyond simple belt tightening into the realms of Mr Scrooge.
( , Thu 23 Oct 2008, 13:58)
« Go Back | See The Full Thread
That's nonsense.
There's no way a switched-off heater can draw power if it's plugged in, on account of how it's switched off. As in, the circuit is physically broken by the on/off switch somewhere just after the power cable gets into the equipment.
( , Fri 24 Oct 2008, 8:32, 2 replies)
There's no way a switched-off heater can draw power if it's plugged in, on account of how it's switched off. As in, the circuit is physically broken by the on/off switch somewhere just after the power cable gets into the equipment.
( , Fri 24 Oct 2008, 8:32, 2 replies)
A lot of stuff doesn't have a broken physical switch
PCs for example still keep the motherboard connected and powered for USB devices. THere's also a current in every extension cable and multi-gang plug due to the voltage difference along the resistance of the wire.
/uncle worked in a power station
( , Fri 24 Oct 2008, 8:35, closed)
PCs for example still keep the motherboard connected and powered for USB devices. THere's also a current in every extension cable and multi-gang plug due to the voltage difference along the resistance of the wire.
/uncle worked in a power station
( , Fri 24 Oct 2008, 8:35, closed)
What about the 30% decrease in power consumption
Is it likely?
/genuinely curious
( , Fri 24 Oct 2008, 9:00, closed)
Is it likely?
/genuinely curious
( , Fri 24 Oct 2008, 9:00, closed)
Ohm Eye God
no voltage drop. No voltage drop - no power loss.
/grandfather worked in a power station
/doctorate in modelling current distributions in conductors
( , Fri 24 Oct 2008, 10:38, closed)
no voltage drop. No voltage drop - no power loss.
/grandfather worked in a power station
/doctorate in modelling current distributions in conductors
( , Fri 24 Oct 2008, 10:38, closed)
there'd be *some*
but not very much.
phone chargers etc do warm up quite a bit when they're plugged in.
stupid transformers.
( , Sun 26 Oct 2008, 17:58, closed)
but not very much.
phone chargers etc do warm up quite a bit when they're plugged in.
stupid transformers.
( , Sun 26 Oct 2008, 17:58, closed)
Have a look for
the +5v(B) jumper on your motherboard- you could just save yourself... well, very little (500mA @5v maximum). But some!
Also, invest in a "smart" power block that turns the peripherals off whenever the PC goes off- I reckon mine's paid for itself this year (a couple of monitors, some speakers, etc all plugged into it).
Like someone below says, there's no voltage drop in the wire, so there's no current flowing. Power is current x voltage, so there's no power loss from a mains extension just being sat there, unless it's one of the ones with a flashing light (cheap surge protected ones).
Power will, however, be lost along the wire when it's providing power to a load as current is flowing through the wire, and the wire has a resistance. This loss is approximately the square root of FA over a 2ft extension, though a surprising amount of heat can be created inside a long coil of wire carrying AC!
/Degree in Mechatronics, several damaged cable-reels.
( , Fri 24 Oct 2008, 17:33, closed)
the +5v(B) jumper on your motherboard- you could just save yourself... well, very little (500mA @5v maximum). But some!
Also, invest in a "smart" power block that turns the peripherals off whenever the PC goes off- I reckon mine's paid for itself this year (a couple of monitors, some speakers, etc all plugged into it).
Like someone below says, there's no voltage drop in the wire, so there's no current flowing. Power is current x voltage, so there's no power loss from a mains extension just being sat there, unless it's one of the ones with a flashing light (cheap surge protected ones).
Power will, however, be lost along the wire when it's providing power to a load as current is flowing through the wire, and the wire has a resistance. This loss is approximately the square root of FA over a 2ft extension, though a surprising amount of heat can be created inside a long coil of wire carrying AC!
/Degree in Mechatronics, several damaged cable-reels.
( , Fri 24 Oct 2008, 17:33, closed)
..
it all depends on where and how close the on/off switch is in relation to the circuit. Also remebber that any capacitors may still be holding a lot of charge. This is cabable of setting up circulating currents between themselves and any inductors.
( , Fri 24 Oct 2008, 8:41, closed)
it all depends on where and how close the on/off switch is in relation to the circuit. Also remebber that any capacitors may still be holding a lot of charge. This is cabable of setting up circulating currents between themselves and any inductors.
( , Fri 24 Oct 2008, 8:41, closed)
« Go Back | See The Full Thread