ooh that sounds good.
I'll learn me up some CAD then. What about the life-size printing bit? Would I have to make it bigger on screen for it to print out in actual size, or is there a way of printing it as it looks?
( Kitty v1.0 desperately naive, Thu 7 Oct 2010, 11:00, 1 reply, 15 years ago)

Have you got a life size printer?
If not then it's fairly pointless.
(PsychoChomp, Thu 7 Oct 2010, 11:04, Reply)

No.
Wiggy mentioned a life size printer too. Can I not make the pattern piece bigger on screen and then just work out the scale from screen to page?
( Kitty v1.0 desperately naive, Thu 7 Oct 2010, 11:06, Reply)

Yes you can,
but it'll invole taping lots of A4 sheets together.
I think the spreadsheet that works out all the dimensions for you would help but it won't do it all for you.
(PsychoChomp, Thu 7 Oct 2010, 11:08, Reply)

Most pieces would probably fit inside A4
the width of most pieces is around 4" and the biggest piece lengthwise is the front centre which is 15" so it would only be maybe two pieces where I would need to tape A4 together, so I could to those two bit in two halves couldn't I?
( Kitty v1.0 desperately naive, Thu 7 Oct 2010, 11:13, Reply)

Or you could just get someone to print them on A3 for you

(PenguinOfDeath is Scottish, and most likely angry, Thu 7 Oct 2010, 11:17, Reply)

I wonder if I could do them half size and then get them photocopied onto A3
I don't know anyone with an A3 printer.
( Kitty v1.0 desperately naive, Thu 7 Oct 2010, 11:19, Reply)

You technically could, yes

(PenguinOfDeath is Scottish, and most likely angry, Thu 7 Oct 2010, 11:27, Reply)

^ This
You would probably need a printers with a barrel printer to get them to print as you needed,
(PenguinOfDeath is Scottish, and most likely angry, Thu 7 Oct 2010, 11:07, Reply)